7/9/2021

I have been concentrating on finishing the nearside rear quarter panel for the last couple of weeks (with interruptions) but at last it is in undercoat after many hours of careful filling and sanding.   I applied the first coat of undercoat using a roller but didn’t brush it out and I wasn’t really satisfied with the finish.  The second coat was sprayed on and it much better.  I will apply a third undercoat and flat that back when it is time to lay on the top coat. I also ground out all the gouges and scars in the stainless steel corner bumpers then polished them.  They are not perfect but acceptable.  And shiny!

Final job for this entry was the fitting (today) of the last two pieces of vertical bearding for the nearside, so apart from paint the nearside is finished!

 

Leave a Reply