Side rod brackets have been painted and fitted. The lower side rod extensions have been drilled, painted and fitted. Worked then turned to preparations for fitting the wiring conduit from the cab to the boot. This included cleaning the chassis under the cab floor and prining ready for silver. Drilling the rear bulkhead in the area of the lower electrical cubicle cover and fitting with the gland to accept the conduit. The chassis from the main brake servo back to just in front of the rear axle has been cleaned and rust beater applied, ready for a coat of red oxide in the coming week. The terminal box for the boot electrics has been sourced and work started on mounting the lid and the screw terminal strip.
Tag Archives: electrical
15/10/2023
This week I have been tidying up the cab ready for reinstalling the floor. I painted the pedals and the handbrake lever and touched up the silver on the chassis to hide the drips from painting the cab. I made and fitted the rubber seal for the handbrake lever, one side to the metal section and the other to the hinged wooden floor section, using the replacement clamp plates I made previously. I fitted the gear lever gaiter to the floor section as well. I need to eliminate the horrid bracket that is holding the fuel pipes and also realign the starter motor cables so they will fit in the floor rebate and not stress the motor terminals. As a change of routine I made two of the remaining three vertical side rods for the offside frame.
8/10/2023
Applying undercoat by spray turned out to be more trouble than it was worth and the finish was just as good from a roller. So I applied another coat to both the o/s rear corner panel and the mudwing. The mudwing will need a bit more flatting and another coat before its finished. This week I have been making starter motor cables and shortening the dynamo cables so they will fit the control box when it is reinstalled. I also applied filler to the bottom of the rearmost o/s panel where it meets the frame and is flat as it fitted poorly to the vertical beading just before the emergency door.