Started the week on beading for the O/S again, but noted an error in the half-round short section which I corrected the following day. Next, I drilled and countersunk the flat beading for the lower waistrail and partially attached it to the body side, drilling reference holes to support it. The next day was fine and warm, so I finished spraying the remaining three wheels and a set of rings. Just the remaining rings to do now. Not much else this week, the last thing I did was to trim the half-round beading of the upper eaistrail so I can fit a slightly longer piece up to the emergency door as I had cut it short, the same error as happened at the cab door. A lot of time was spent setting up and practicing with the new Mig/Tig welder. The final job of the week was to cut a short section of half-round beading to complete the O/S upper waistrail.