15/9/2018

Distracted by car maintenance today so all I managed to do was tighten the O/S hub nut, fit the locking screws, nuts and split pins to the hub nut and refit the half-shaft.

14/9/2018

Refitted rear hubs today, very difficult to get the the axle hub nuts back to their original positions and I didn’t achieve this on the nearside.  The manual says .004″ play is acceptable in the hub bearings  but I can detect none at all, maybe something to be checked again after a bit of running.  Nearside hub is fitted, offside is on but not tightened up.  I had to make a replacement locking screw and castellated nut, as each axle nut requires two and one was missing  when I stripped it all down.

20180917_170953

 

20180917_171007