Spent today sanding and fitting up the three pieces of timber that make up the forward lower section of the wheelarch.   I just about completed these by finishing time.

Finished checking and adjusting the window frames today.    As predicted, only two needed adjustment, all the rest were spot-on.

After that I started work on the wheelarch framing, removing the lower forward section and used it to mark up cut out a new piece of timber.

Finished welding and fettling the last window frame today.  However I need to check the other for dimensional accuracy, as at last one is out by 1/4″ at the top.  This is easily rectified by cutting a slice out of the top horizontal and strapping the sides with a ratchet strap with a jig bar of the correct size between the uprights.    With this setup I was able to weld the top horizontal in the correct position.  I think this problem is only likely to affect the first two or thee that I made, so nearly there.