Shot a coat of silver over the rear of the entrance steps sheet metal – i.e. the side that faces the chassis and won’t be easy to reach when its all assembled. Final coat goes on tomorrow.
Monthly Archives: June 2019
23/6/2019
Finished filling and sanding the curved section of the entrance step metalwork and shot two coats of red oxide primer over the whole lot.
22/6/2019
With the timber now in stock I cut the first lower side rod section. However I was unable to finish it as the belt sander motor burnt out.
I started to assemble the previously prepared and painted floorboard pieces and ran into two problems. Firstly, one of the pieces seems to have vanished and secondly even if I had it, it would no longer fit. As this job really was not a good ‘un, I decided to make a couple of replacement sections and paint them after fitting as it seemed they grew during painting!
I examined the sheet metal for the entrance steps after the first coat of primer and decided the curved section needed to be improved with a skim of filler, so applied the first couple of layers and sanded it.