4/9/2019

Fabricated a new piece of cladding for the bottom of the entrance rear pillar as the one I had made by panel beating was really not good enough.  I made this one in aluminium by welding which took some time to achieve but is much more satisfactory.

Then I finished grinding flat the welds in the fairing panel that fits behind the nearside wheel and started to strip the paint from it.  I noted that this had been painted cream above the waist at some point.

Cladding for bottom of rearward entrance pillar

Cladding for bottom of rearward entrance pillar

View of the welded edge

View of the welded edge

Upper welded repair to valance

Welded repair to upper split in valance

Welded repair to lower split in valance

Welded repair to lower split in valance

3/9/2019

Undercoat applied to the  window in the rearward entrance bulkhead and a second coat to the two windows in the front bulkhead.  I welded up the cracks in the shaped aluminium valance panel that fits behind the nearside front wheel.  So far this looks successful,  I reinforced behind the cracks with some small pieces of beading.