Sprayed the nearside chassis side member with red oxide as far as the rear of the engine bay, using a brush to get to the top and bottom surfaces that the spray gun couldn’t reach.
Sprayed the new steel plate for the entrance pillar with green smooth hammerite.
Paid attention to the steel reinforcing plates that connect the side rods to the floor cross bearers. Those on the nearside between the axles were wire brushed then two coats of Vactan applied ready for red oxide tomorrow.
Painted the rest of the entrance step frame with silver smooth hammerite this morning. This afternoon I made all the side rod brackets for the near side, noting the subtle angle of the top flange that allows the bracket to follow the curve of the lower side rod legs.
New side rod brackets. These attach the lower legs to the main part of the side rod and abut the floor.
Restoration diary of a 70-year old AEC single-deck bus and the trials, tribulations and adventures of our 1966 Bristol bus.
